Notification
27.02.2017
ST16 Firmware Update B30

With the new ST16 software update B30 a new pre-heating function is introduced into your model. In addition, the OTA update function has been improved, additional preinstalled cameras and the Tornado H920 Plus were added as well as a note to the just used photo mode. 

These are the new features:  

 

PRE-HEATING THE ACCELERATION SENSORS

If the ambient temperature is too low, the IMU (Inertial Measurement Unit) must preheat before starting. If the temperature is too low, a warning is displayed on the ST16 and the main LED shines yellow.

 

H920 PLUS MODEL

The ST16 is now compatible with H920 Plus. 

 

PHOTO MODE NOTE

Next to the small wheel setting symbol a note will appear indicating the current used photo mode.

 

ADDITIONAL CAMERAS

CGOET and CGO4 were added to the camera menu. Please be aware that the CGO4 is only compatible with the H920.

 

IMPROVED OTA

The "Over the Air" (OTA) update function was improved.

 

 

ATTENTION!

To be able to use these new features, you must ensure that at least autopilot version 1.29 or higher and at least camera version 3.2.32 or higher are installed. After the update we recommend to do an accelerometer calibration.

Get software version 3.0 here for free.